UV ADHESIVE - UV GLUE - DIY AND INSTALL YOUR TRIT VIALS

UV ADHESIVE - UV GLUE - DIY AND INSTALL YOUR TRIT VIALS

This is a UV Adhesive (Glue) that cures (hardens and dries) under a UV Flashlight. Perfect to install your tritium vials!

SPECS

Model: Loctite 3217 UV Adhesive / UV Glue
Available in 1 cc, 2 cc, or 3 cc plastic bottles
Size of the bottle: 3 cm x 1.5 cm
Cure time: 1 minute Under UV Light

"HOW DO I INSTALL MY TRITS?"

Installing trits is super easy. Just follow this simple step by step and you will have your spinner fully "trited" in no time!

Before starting, make sure you have in hand the following items:

* A Spinner with Trit Slots
* Trit Vials
* 1 UV Flashlight (click here to get one)
* 1 UV Adhesive

1 - Put 1 small droplet of UV Adhesive inside your trit slot. You can use a toothpick to collect that droplet first instead of applying directly with the UV Adhesive bottle nozzle. If some UV Adhesive touches the body of the spinner, don't worry, just wipe with a soft tissue. It's really easy to clean.

2 - Place your trit inside the slot, over the UV Adhesive and position it centered in the slot.

3 - Place your UV Flashlight about 5 cm directly over the slot with your tritium and leave the UV Flashlight ON for 1 minute.

4- Done! Now, repeat the same steps for all the other trit slots.

TIPS:

* The UV Adhesive will usually cure in 10 seconds after you apply the UV Light on it, but, we recommend leaving 1 minute to make sure it's really cured and dry.

* Before turning your UV Flashlight on, make sure to take the UV Adhesive bottle away from that light, otherwise the Adhesive may cure inside of the bottle.