Beta QRv2/3 Pocket Clip

The best key chain flashlight...just got better!

Clip cap is now offered in 6/4 Titanium! 

One of the main reasons I wanted to switch over to the Beta QRv2 was so I could do THIS! Ta da! A pocket clip. Boom goes the dynamite.

I'm not sure there is a lot to talk about. Did I mention boom goes the dynamite? The clip holds securely but it does rotate. This is going to upset some people, but that's just the way it's got to be. I mean, come on, I made it pocket clip compatible...let's get excited about that part!

Material: We use ASTM Certified Domestic 6Al/4V titanium, which is 50% more expensive than consumer grade titanium, to insure maximum quality and consistency. 

The Brass caps are machined 100% in-house on our Haas ST10-Y lathes. The Beta clip also allows perfect tail standing!

The only "trick" is actually getting the pocket clip back off once the cap is snapped in place.

The best way is to loop some cord around the clip and pull it off. Use finesse, not brute force. If you damage the clip it's not my fault.

1. Grab the light and put one thumb on the clip like you are going to push it backwards off of the light...because that is what you are doing.
2. Loop the cord around and pull on the cord at the same time you are pushing with your thumb.
3. The clip (and cap) should pop right off. Now turn on your light and look under the couch for the brass cap.
4. The key is that the cap must be pulled "straight" out of the light. If you only push with your thumb or only pull with the cord, you'll be pulling the brass cap to one side (not straight out) and the brass cap will say, "no thanks, I'm staying right here."

Of course I recommend (*shameless self promotion*) using one of my zipper pulls for this honorable duty, but you can use just about anything...if you must.